SenTek Training Classes and Seminars
SenTek provides a wide variety of training classes and seminars for our customers. These training classes are held both at our customers' plant sites and at SenTek's facility in Columbus.
Our training classes are intended for the engineers, technicians, operators, electricians, and millwrights who install, operate, maintain, and calibrate X-ray and isotope gauges and scanners. These classes and seminars are set up as a modular system, where the customer can combine one or more modules to a training program that is most appropriate for their needs.
Our training classes are intended for the engineers, technicians, operators, electricians, and millwrights who install, operate, maintain, and calibrate X-ray and isotope gauges and scanners. These classes and seminars are set up as a modular system, where the customer can combine one or more modules to a training program that is most appropriate for their needs.
STK-101 Basic SenTek Gauge System Service and Maintenance
This is a one-day class for the SenTek 1000 or 500 systems that covers the following topics:
- System architecture, power supplies and circuit protection, wiring and cabling, interlocks and safety features, operator screens, maintenanace and diagnostics screens, system configuration and file archiving, reboot and re-start procedures, and log-on and access control.
- System architecture, power supplies and circuit protection, wiring and cabling, interlocks and safety features, operator screens, maintenanace and diagnostics screens, system configuration and file archiving, reboot and re-start procedures, and log-on and access control.
STK-102 Advanced SenTek Gauge System Service and Maintenance
This is a one- or two-day class for the SenTek 1000 or 500 systems that builds on the STK-101 class, and covers the following additional topics:
- Signal processing and board-level architecture, Calibration table tuning and adjustment, common faults and advanced troubleshooting, DAC set-up and tuning, PC setup, rebuild, and replacement, as well as other topics as necessary.
- Signal processing and board-level architecture, Calibration table tuning and adjustment, common faults and advanced troubleshooting, DAC set-up and tuning, PC setup, rebuild, and replacement, as well as other topics as necessary.
THK-101 Absorption Gauge basics
This is a one-day class for thickness gauges that covers the following: Absorption curves, base calibration, alloy and product calibrations, Ion Chamber fundamentals, Electrometer and Detector circuitry, Standardize, sample check, and other program functions, and basic thickness gauge troubleshooting and maintenance.
THK-102 Beta and Gamma Gauge training
This is a one-day class for thickness gauges that covers the following: beta and gamma sources, beta gauge geometry, flutter tuning, alignment and swing head principles, gamma gauge geometry, beta gauge calibration and accuracy challenges, gamma gauge calibration and accuracy challenges, and beta and gamma gauge troubleshooting.
This class is normally provided with the installation of a new SenTek system.
